The controller CW01R66 could operate with different modes for pause depending on the client's preference.
The determination, when the system is paused, is done by the settings of the parameter „Relays - reporting time“ in the group „Buttons and relays“. If one of the marked relays is not active that means that the system is paused.

The absence of a physical button for pause means that the system cannot be put in this mode.

The setting 0 to the parameter „Resetting the time after waiting for the pause“ in the group „Buttons and relays“ means that the system is paused for an unlimited time.

Setting a time for the parameter „resetting the time after waiting in pause“ in group „Buttons and relays“ shows the maximum time permitted for the user to remain paused. After the time is up, the available credit is reset. In this mode, at the bottom part of the screen appears a line with the remaining time. This time is saved in a repeated entry in pause and is reset only by charging with a new credit.

Another type of pause is this, using the available sum. Achieving this requires the following settings: parameter „Relays - timekeeping“ is left without active relays, for parameter „Resetting the time after waiting in pause“ is set zero. In „View - work“ is made a new regime for pause with „state of the relays“ - inactive for every single one and individual time, according to how many seconds „costs“ each pause.

Normally, after charging the machine with credit, it becomes in pauses, waiting for the user to make their choice for a program. This step can be skipped by setting the „Relays - initial state“ parameter in the „Buttons and Relays“ group to a state advising one of the programs.